Forum Replies Created

Page 23 of 42
  • johnb

    Member
    February 25, 2017 at 9:20 am in reply to: Dodecylhexadecyltrimonium Chloride

    What I am asking is for a reference to where you get the information that this substance does have the property of being an exfoliant.

    I cannot believe that a material normally used as a hair conditioner will itself have exfoliating properties. Possibly it is included in the product for another purpose.

  • johnb

    Member
    February 25, 2017 at 8:12 am in reply to: Dodecylhexadecyltrimonium Chloride

    Please explain how it does this or give a link.

    I can find no references to the end use that you claim.

    I still maintain that it is a cationic detergent most often used as a hair conditioner. However, it a an uncommon material (perhaps because of its high cost).

    Check out https://pubchem.ncbi.nlm.nih.gov/compound/21917627#section=Top

  • johnb

    Member
    February 25, 2017 at 7:53 am in reply to: Dodecylhexadecyltrimonium Chloride

    Dodecylhexadecyltrimonium Chloride is a fairly unusual cationic detergent used mostly as a hair conditioner. It is NOT an exfoliator although it may be included in exfoliator products for other reasons.

  • johnb

    Member
    February 25, 2017 at 7:43 am in reply to: Seeking Chemist for Antioxidant Mist

    What is the purpose of this “antioxidant mist”?

  • johnb

    Member
    February 24, 2017 at 8:51 am in reply to: Mgnesium Chloride based deo formulation

    Not sure about long term safety of the sulphate salt or its effectiveness for this application. 

    I’m yet to be convinced of the effectiveness (or esthetics) of the MgCl2 for this application.

  • This effect is very common when making emulsions by phase inversion (that is adding the major phase to the minor phase during emulsification).

    The phase inversion method is a very good way of making “fine grained” emulsions but does need careful mixing. You may find a paddle impeller better than the saw blade and it is definitely worth trying.

    The http://www.ebay.com/itm/Propeller-PTFE-Paddle-Used-at-low-to-medium-speeds-Impeller-50mm/192100167546?_trksid=p2047675.c100623.m-1&_trkparms=aid%3D222007%26algo%3DSIC.MBE%26ao%3D1%26asc%3D41375%26meid%3Da8c6692cd240460d97999e011a9b223e%26pid%3D100623%26rk%3D3%26rkt%3D5%26sd%3D192100167545 may be a better choice.

  • johnb

    Member
    February 24, 2017 at 7:54 am in reply to: Potential for Sodium Benzoate forming Benzene with Iron oxides

    The answer, obvious to me, is to remove one or both of the potentially offending materials.
    Benzoic acid? Use a different brand of botanical which does not use benzoic acid as a preservative. Why are you using botanicals in a functional product like this? It is not doing anything useful.
    Ascorbic acid? Plenty of other materials available which can replace this in cosmetic products.

    As Bill says, though, the risk is negligible.

  • johnb

    Member
    February 24, 2017 at 7:41 am in reply to: How to Stabilize formulation with colloidal Gold Solution

    I appreciate you want a stable formulation but what function or effect does the colloidal gold achieve that cannot be obtained with other, more compatible materials?

    Does the gold achieve the effect you want (presumably removal of dark circles)?

  • johnb

    Member
    February 23, 2017 at 3:12 pm in reply to: EDTA and Carbopol

    It depends a lot on other aspects of your process.

    The best way to answer your question is to try it youself and see.

  • johnb

    Member
    February 23, 2017 at 11:13 am in reply to: How to Stabilize formulation with colloidal Gold Solution

    What is the effect you want?

  • johnb

    Member
    February 23, 2017 at 8:11 am in reply to: Tremendously drop of viscosity

    As Bill says, solid forms of Bentone require careful “activation” to realise their full potential.

    Predispersed Bentones are far easier to use.

  • johnb

    Member
    February 23, 2017 at 7:54 am in reply to: How to Stabilize formulation with colloidal Gold Solution

    Regarding the gel you have been testing (without the gold). Does that perform in the way you want your final product to perform?

    If it does then there is no point in including any gold in the product.

  • johnb

    Member
    February 22, 2017 at 6:05 pm in reply to: What preservative for syndet bar?

    :)

  • johnb

    Member
    February 22, 2017 at 4:04 pm in reply to: What preservative for syndet bar?

    You must be very old, DRBOB.

  • johnb

    Member
    February 22, 2017 at 3:48 pm in reply to: Same recipe but product has changed.

    It is not the main function of this material to act as a scent and I doubt this aspect would be anywhere on the list of requirements for the herb.

    As far as I remember, there are two types of Rooibos marketed, one fermented and one not. Only the fermented herb has the brown colour.

    I recall that the odour of rooibos is redolent of methyl salicylate (wintergreen) perhas including some of that will overcome the malodour you are complaining about

  • johnb

    Member
    February 22, 2017 at 9:04 am in reply to: Tremendously drop of viscosity

    Please be aware that not everyone uses Microsft Office.

  • johnb

    Member
    February 22, 2017 at 8:20 am in reply to: What preservative for syndet bar?

    Assuming that your bar is an alternative to toilet soap as a personal cleanser, have you considered the problems there are in formulating a bar that will sit in a soap dish and not turn to mush?

    The biggest selling non-soap “soap”, Dove, contains a large quantity of real soap in an effort to give “dish stability”. I doubt that your formula will do that.I worked for Unilever at the time Dove was being developed and although I was not directly involved in its development work, I was aware of the difficulties associated with the poor “dish stability” and, even now, syndet bars and “combi” bars (such as Dove) have poor integrity on storage in a soap dish.
     

    LOI Dove:

    Sodium Lauroyl Isethionate 
    Stearic Acid
    Sodium Tallowate Or Sodium Palmitate (Soap)
    Lauric Acid
    Sodium Isethionate
    Water
    Sodium Stearate (Soap)
    Cocamidopropyl Betaine
    Sodium Cocoate Or Sodium Palm Kernelate (Soap)
    Fragrance
    Sodium Chloride
    Tetrasodium Edta
    Tetrasodium Etidronate
    Titanium Dioxide (CI 77891).

  • johnb

    Member
    February 22, 2017 at 7:49 am in reply to: Looking For Cosmetic Chemist For Cannibis Infused Cosmetics in Cali

    What are the attributes of cannabis derived ingredients that you feel will be useful in cosmetic products?

  • johnb

    Member
    February 21, 2017 at 4:14 pm in reply to: How much alpha arbutin in a cream?

    Arbuting releases hydroquinone (banned in cosmetics in Europe) and there has been/is debate as to whether its use as a skin lightener should continue to be permitted.

    I would not consider using arbutin in a new cosmetic.

  • johnb

    Member
    February 21, 2017 at 2:22 pm in reply to: Mgnesium Chloride based deo formulation

    OK, There are few (no?) MgCl2 deo products on the market. If it really worked, why are the aluminium containing products (with all their bad press) not being rapidly replaced by MgCl2 alternatives?

  • johnb

    Member
    February 21, 2017 at 1:39 pm in reply to: Mgnesium Chloride based deo formulation

    Emollient/humectant or a water soluble silicone will not increase evaporation rates to provide faster drying.

    Are you really convinced that MgCl2 is effective as a deodorant? As I mentioned in my first reply here, as far as I know, there are no commercial products using magnesium salts as actives in deodorants/antiperspirants. If it really worked, I would have expected the market to be overflowing with products to counter the anti-aluminium mafia.

  • johnb

    Member
    February 21, 2017 at 12:01 pm in reply to: Propylene Glycol Extract of plants

    Which site? I’ve not given any links here.

  • johnb

    Member
    February 21, 2017 at 8:55 am in reply to: Propylene Glycol Extract of plants

    There is no point in extracting vitamin C. It is so low cost that extraction is not worth while.

    Regarding papain, there are recognised methods of collecting the papaya latex and extracting the papain from that. I doubt it involves propylene glycol.

  • johnb

    Member
    February 21, 2017 at 8:39 am in reply to: anionic surfactant solid thickners

    You will get more replies if you give more details of what you are trying to achieve.

  • johnb

    Member
    February 21, 2017 at 8:36 am in reply to: How can I get crystal clear transparent soap?

    The big problem with using alkanolamine soaps is that they do not solidify.

Page 23 of 42
Chemists Corner