

francisa
Forum Replies Created
-
@PhilGeis I didn’t take the pH of my water phase. If it’s too low will that affect the solubility of the Disodium edta?
-
-
@Perry thank you for your response. What preservatives would you recommend? I’m trying to stay away from any ingredients that could be considered “harmful”.
-
Thank you for your response. It’s a scalp leave on spray. The ingredients listed below:
Water
aloe Vera powder
glycerin
disodium edta
euxyl k903Sorbitan Oleate Decyl. Crosspolymerpeppermint oil
vitamin esaw palmetto extract
horsetail extract
neem extract
kerascalp
Baicapil -
@Gordof Thank you so much for your advice. I was trying to stay away from PEGs to solubilize which is where the Sorbitan Oleate Decyl came in.
One more question if I may. Do you think the preservative chosen will suffice at the amount I’ve listed? -
thank you so much for such a thorough response!
-
francisa
MemberJanuary 28, 2021 at 8:33 pm in reply to: Is this too much for a hair mask formulation?Okay thank you very much!
-
francisa
MemberJanuary 28, 2021 at 7:42 pm in reply to: Is this too much for a hair mask formulation?@Perry thank you! Could I get the same effect and make it cheaper if I reduce the conditioning agents?
-
francisa
MemberJanuary 28, 2021 at 7:03 pm in reply to: Is this too much for a hair mask formulation?@Perry and @Paprik I’ve changed the formula and reduced the behentrimonium chloride. I’ve achieved the softness of hair and slip. Do you suggest I reduce the conditioning agents more? Here is the water and oil phases.
water: qs
cetrimonium chloride: 3%Propanediol 1,3: 4%Guar hydrox. Chloride: .5%BTMS-50: 4%Cetearyl Alcohol:5%Caprylic Triglyceride: 5%Sunflower oil:5%Babassu oil:2%Cocoa butter: .5% -
francisa
MemberJanuary 28, 2021 at 6:45 pm in reply to: Is this too much for a hair mask formulation?@Paprik thank you!