Tagged: 

  • microformulation

    Member
    December 10, 2018 at 9:27 pm

    There is no set speed. It is dependent upon so many factors. It takes Judgement and a knowledge of the different blades and their proper uses.

  • ngarayeva001

    Member
    December 10, 2018 at 10:21 pm

    Anchor blade is kinda foolproof.

  • chemicalmatt

    Member
    December 12, 2018 at 10:43 pm

    …what Mark said…and then some. The veteran chemists in this blog could collectively author a textbook on the many modes of and tools and uses for mixers and how these variations perform with different formulations, circumstances, colloidal additives, etc, etc, etc, IS the speed important you ask? As so often the case: depends on the application. Try and see.

  • em88

    Member
    December 13, 2018 at 11:03 am

    Anchor blade is kinda foolproof.

    Thinking to buy an anchor blade. Do you use it for the hole process or just for the cool down phase? I’m kind of lazy to change blades during a test. :smiley:

  • nara

    Member
    December 15, 2018 at 2:41 pm

    Thank you?

Log in to reply.