jenchemist
Forum Replies Created
-
BPI labs can do this.
BPI Labs | Private Label, Personal Care and Cosmetic Manufacturer -
MurtazaHakim said:What about the black dot on the topside for alignment??? Should it be in the middle always during the measurement of viscosity ???
Yes
-
Hi, I have the same model. Angle should read between 20% and 85%. If not within that range, you will need to adjust the rpm. If adjusting the rpm doesn’t fix the angle, change the spindle size too.
-
Thank you everyone.
-
Polysorbate 80, twice as much as the amount of fragrance you’re trying to solubilize. It’s viscous but to me not as sticky as a glucoside. If that doesn’t work, then combine the Polysorbate with another nonionic surfactant.
-
Vendor recommendation is for how to use their specific product. So recommended % usage applies to the whole solution, no other math required.
-
frenchcolor.com has FDA-certified glycerin-based dyes that are pretty UV-stable. I’ve had a lot of success with them for products in clear bottles.
-
I did a lot of work with MaxxThix PC 10 and truthfully I don’t think you can get a good gel that doesn’t feel awful. It is not a good product for this application.
-
Ahmad said:I am having tough time during making ng 80% ethanol gel as it consumes more carbopol and due to high prices it’s cost goes higher…
A customer want it with WHO recommendations but with gel not liquid I mad it once but its tolerance towards TEA is very low at higher concentration.
I have a meeting today in evening for this quality requirements. What should be the best percentage of Ethanol that can work in these conditions?You should be able to use 80% ethanol with carbomer. Neutralize with AMP Ultra instead of TEA.