-
help in a foaming serum
hello, I created a fluid emulsion as a face serum and it is leaving a white cast. any advice how could I minimize it?
PHASE A:
AQUA 55.2%
glycerine 5%
1% hyaluronic acid 20%
PHASE B:
fluidfeel easy 3%
isopropyl myristate 5%
Caprylic/capric triglyceride 10%
SOLAGUM AX 0.8 %
PHASE C:
liquid germal plus 0.5%
parfum 0.5%
-
4 Replies
-
The white cast can happen when the emulgator foams a little bit and then the gum stabilizes the foam. So I would try to play around with the concentration of the emulgator and the gum to where the emulsion is stable and it doesn’t foam as much. The emulgator INCI does have two surfactants (Lauryl glucoside and Myristyl glucoside), which can be problematic, when the formulation contains a high concentration of gum to stabilize the foam. If it still foams after you lowered the emulgator I would try to use another one. You can also try to add a litttle bit of dimethicone, which helps to get rid of the white cast.
-
Appreciate your response! would you recommend a good cold emulgator for fluid emulsion? or should I use polymer instead of gums? also the formula turned out to be not stable is there any advice on how to stabilize it?
-
-
This type of serums doesn’t have an emulsifier. Instead, it uses its thickeness to suspend oils. The White cast could be do to the hyaluronic acid or the gums.
-
noted thank you!
-
Log in to reply.